Witten Vent 306MWH Foundation Vent, 65 sq-in Net Free Ventilating Area, Mesh Grill, Thermoplastic, White

This cordless hammer drill driver is designed for enhanced power with a 1,650 RPM no-load speed during use. It’s designed for maximum power with up to 404 UWO and 28,050 blows per minute in hammer mode. It features a variable-speed transmission and trigger with 15 clutch settings so it’s easy to select the right setting for the job at hand. It’s also designed with high bit retention and a 1/2″ ratcheting chuck. This tool features an onboard LED light for illumination and maximum efficiency and is ideal for concrete and masonry applications.

Kit Includes:
– Hammer drill driver
– Lithium-ion battery
– Charger
– Storage bag
– Belt hook

Tool Dimensions:
Length: 6 15/16″
Width: 2 1/2″
Height: 7 15/16″

This unit features soft-touch, over-molded plastic housing, and it is drop test rated for up to 9 13/16′. It is IP54 rated for dust and water resistance. This thermometer comes with a 9V battery, which provides up to 8 hours of continuous use with the laser and backlight on. An auto power off mode helps to conserve and extend the battery life. This tool comes complete with a convenient storage pouch.

Overall Dimensions:
Length: 7″
Width: 2 1/16″
Height: 4 1/2″

This hard hat includes a rechargeable, magnetic LED headlamp to illuminate your jobsite. It provides 300 lumens and up to 4 hours of use in boost mode, 215 lumens and up to 9 hours of use in spot / high mode, and 100 lumens and up to 14 hours of use in flood / low mode. A cord is included to recharge the lithium-ion battery. This hard hat also includes dual accessory mounts on the front and back and universal side slots to accept additional accessories (sold separately). It meets Type 1, Class C standards as well as ANSI/ISEA Z89.1-2014 and CSA Z94.1-15 requirements for industrial head protection.

Overall Dimensions:
Length: 12 11/16″
Width: 10 15/16″
Height: 5 13/16″

This kit also features 1 cordless drill driver designed for enhanced power with a 2-speed, 0-450 RPM / 0-1,500 RPM transmission with 16 clutch settings so it’s easy to select the right setting for the job at hand. It’s also designed with a 1/2″ single-sleeve ratcheting chuck for tight bit gripping strength and an ergonomic handle for comfort and control. This set is ideal for construction and repair applications with driving tasks that include spade bits, large-diameter screws, and large fasteners.

Kit Includes:
– Drill driver
– Impact driver
– Charger
– Contractor bag
– (2) Lithium-ion batteries

Impact Driver Dimensions:
Length: 5 9/16″
Height: 8 9/16″

Drill / Driver Dimensions:
Length: 8 5/8″
Width: 2 15/16″
Height: 7 9/16″